Splicing Into Existing Trim

By Robert Robillard

 Splicing Baseboard Trim – A Carpenter’s Tip I love rules of thumb and quick tips!   Here’s a quick tip that can be used when remodeling and you need to cut in a miter or splice along a length of existing trim board. Why would you need to use this, well here’s a few examples: Cutting…

Continue reading »

Hitachi C8FSE Sliding Compound Miter Saw

By Phil Benevides

The Hitachi C8FSE 8-1/2″ Sliding Compound Miter Saw on the ACC Job-site I’ve been hauling around a massive 12-inch compound miter saw, which has been taking up some serious real estate in the back of my SUV, (also known as my work vehicle) for WAY too long. I’ve used plenty of Hitachi saws on various…

Continue reading »

Bosch CM10GD Dual Bevel Glide Miter

By Robert Robillard

  Bosch Axial-Glide 10-inch Dual Bevel Glide Miter Saw CM10GD If your workshop is similar to mine you have a lot of dead space, tons of free walls and lots of free area on the open floor, right? Well not exactly, my shop is cramped, crammed and real tight. I recently had the opportunity to…

Continue reading »

SKIL 12 Inch Compound Miter Saw

By Robert Robillard

SKIL 12-inch Miter Saw, model 3820-02 The folks at SKIL recently sent me their SKIL 12 Inch Compound Miter Saw to evaluate and review. First Impression: The SKIL 12 Inch Compound Miter Saw came with very little assembly.  It has a 15 amp motor that produces up to 4,500 rpm.  A vertical clamp is supplied and can be used…

Continue reading »

© Copyright 2019 A Concord Carpenter · All Rights Reserved