Half Wall Bookcase
After the glue dries we used a router to make the round over edge on the nosing. Normally /i would do this type of routing on my router table but the shelf top is over 13′ long and difficult to manage.
Half Wall Return Cabinet
Below is the return bookcase that will sit on the wall at the steps. this section will have an open back so you can see through it.
A 3/4″ face frame was applied to the vertical edges and nosing applied to the top – clamps waiting for the glue to dry.
The small, two sided, return bookcase sanded and ready for install.
Checking for fit before gluing the frame and back together. Two of these sections will be joined together to get the 13′ bookcase length we need for the long section of the 1/2 wall.
If you enjoyed this post, make sure you subscribe to my RSS feed!
